|
|
||||||
| Newbies and Introductions If you are new this forum you can meet the other members in here and introduce yourself, let us know about what your boating interests are and any other hobbies for that matter. |
 |
|
|
Thread Tools | Display Modes |
|
#11
14-04-2012
|
|||
|
|||
gearbox
a bit complicated the centre pin from the gearbox i had machined to fit in the centre of the flywheel...it still left a four inch gap all around to fill in which i did with steel channel cut and welded drilled bolt holes where needed then bolted it together getting it lined up was a bit awkward though
|
|
#12
14-04-2012
|
||||
|
||||
|
The gaffa tape on the prop..............for balance
 ?
__________________
I do not, do...if's... buts... or maybe's ! If you,re busy doing nothing...........how do you know when you,ve finished ? You can only be certain of three things....Tax...death and RTH !... WARNING....Russ T is a hazard to himself let alone others so any advice he offers is to be treated with suspicion and acted upon at your own risk !!!!!....
|
|
#13
14-04-2012
|
|||
|
|||
|
ha ha underneath is a bolt joining the flange to the shaft...should have been one with a castellated nut but lost it when i removed the shaft the other week so only temporary....but the 1-1 gearbox is not really good for this setup as had to fit a small prop as very fussy
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Display Modes | |
Linear Mode
|
|
All times are GMT +1. The time now is 15:19.
This site and its contents copyright 2010 onwards to PracticalBoating.com and Friday Holdings Ltd.